Remove black joints from bathroom or kitchen tiles effortlessly: an effective method

If floor tiles are quite easy to clean, the same cannot be said for joints that wear out over time. Its maintenance thus becomes essential and this is the intention of the solution that we are going to share with you thanks to a product that will surprise you.

It is not only important not to neglect the maintenance of the tile joints for reasons of hygiene but also to   avoid the formation of cracks.  These can promote water penetration, causing tiles to peel off and this is the last thing you want to see on a tiled floor or wall. To effectively maintain tile joints, here is a simple but relatively effective technique.

How to maintain tile joints effortlessly?

It only takes a few days for the joints of the coverings or floor to end up blackening after washing. A problem that requires being intelligent having more than one trick up your sleeve. As ? Adopting this method that allows you to whiten the tile joints  .

To achieve this, you can count on a product that is not uncommon to find at home:   a white candle  . In fact, the wax of the latter will allow you to create effective protection in the joints that separate the tiles. To begin, clean the seals as usual, freeing them of dust and allowing them to dry. Then take the white candle and rub its tip against the joints, making sure to remove the wick from the candle. In this way, a protective film will be created that will allow the joints to be whitened, delaying the excessive formation of dirt.

If   your bathroom tiles   are full of scale and soap scum, then the baking soda and white vinegar formula is a must. Don’t hesitate to apply it in addition to the technique mentioned above.

What cleaning techniques should be encouraged before using the candle method?

Before trying to whiten the gaskets directly with the spark plug, you should first clean them in several ways,   depending on how dirty they are:

For slightly dirty joints

If there are only small areas to treat,   a used toothbrush   and toothpaste will do the trick. However, you will have to do it differently if you plan to clean a larger area. In this case, mix baking soda with hydrogen peroxide to obtain a paste to apply directly to the surface. Leave it on for about 5 minutes and then rinse with clean water.

For moderately dirty joints

In the case of moderately dirty joints, you can count   on   the disinfecting power of white vinegar and the abrasive property of baking soda  . Mix 4 tablespoons of baking soda with 10 cl of white vinegar, then dip a washing brush into the resulting solution. Scrub the seals and then give them a long rinse with clean water before drying the surface with a clean, dry cloth.